Sentence examples for medium steam from inspiring English sources

They produce low to medium steam pressures up to 18 kg/cm2 [7, 8].

Coconut shell gasification Modified Ecoinvent 2.0 module for assessing the impact associated with crushed coconut shell gasification in a FB gasifier with steam and air as gasification medium Steam for gasification Modified Ecoinvent 2.0 module for steam generation.

Figure 8 includes some additional values for maximum fuel and medium steam extraction, which is why a slightly non linear trend of the upper map restriction can be seen for the Ebsilon results.

The experimental results depict that the minimum cleaning cost, however, is accompanied with overheating of milk consuming excess energy and a higher outlet temperature of the heating medium (steam) causing excess requirement of steam.

The effect of temperature (°C), heating rate (°C/min), gasification medium (steam or air), air ratio, steam to biomass ratio (S/B) as well as the catalytic effect of Fe naturally dispersed in the biomass char were studied.

In this gasifier, coal (usually crushed to less than 12 millimetres) is fed by a screw feeder and is fluidized by the gasifying medium (steam-air or steam-oxygen, depending on the declared calorific value of the product gas) entering through a grate at the bottom.

The plants used medium pressure steam boilers (21 bar and 300 °C) and backpressure steam turbines.

The utility of this algorithm is demonstrated on a simple flow network, a small but realistic evaporator system, and a medium sized steam metering network.

Methods for the isolation of hemicelluloses from biomass include extraction in alkaline, alkaline peroxide and liquid hot water medium or steam explosion-based extraction, and other procedures based on slight modifications (Peng et al. [2012]; Verbruggen et al. [1995]).

The heat exchanger network of a nitric acid plant has been studied and it was found that it is possible to reduce requirements for cooling water and medium pressure steam.

Gas turbines for CHP systems are cost-effective in commercial or industrial applications with a generating capacity above 5 MW, and are often used for district energy systems because their high quality thermal output can be used for most medium pressure steam systems [13].