Sentence examples for mechanical properties started from inspiring English sources

For normal strength concrete residual mechanical properties started to decrease at 100 °C, while using silica fume reduced the losses at high temperatures.

Studies of polypropylene with different degrees of isotacticity have shown a way of the rational design of material with predetermined mechanical properties starting from the synthesis stage already – controlled introducement of stereodefects will allow the smooth adjustment of the Young's modulus and elasticity in the range from plastic to elastomer materials.

As the toughness of conventional ATZ composites is moderate it was tried to improve the mechanical properties by starting from a very tough and transformable 2.5Y-TZP powder derived from powder coating.

It is observed that there is an improvement in the mechanical properties when the starting material is ECAP-processed before carrying out the isothermal forging.

The consolidation and densification phenomena are affected by the mechanical properties of the starting powder [6, 7].

To fabricate optimized ceramic-based polymer composite thick films by the AD process, it is necessary to understand how the mechanical properties of the starting powder affect the characteristics of the composite films.

"Clean up the properties starting tomorrow.

Knowledge of the relationship between the penetration depth and the contact radius is required in order to determine the mechanical properties of a material starting from an instrumented indentation test.

For fabrication of ZrO2-based ceramic materials with final sintered properties of high tetragonal-phase (t-phase) content, along with dense and uniform microstructure leading to good mechanical properties, it is preferable to start with a concentrated nanopowder suspension with an appropriate dispersant stabilizer [25].

This severe plastic deformation (SPD) process is used in order to achieve a starting material with a submicrometric structure, thus improving the mechanical properties of the part.

To start with isotropic mechanical properties, a uniform fiber distribution (with initial values for α and β of 45° and 100, respectively) is used.