Sentence examples for mechanical properties corresponding from inspiring English sources

The gradient composites supported tunable mineralization and mechanical properties corresponding to the spatial concentration gradient of the mineralization domains (R5 peptide).

The tensile testing measurements showed that the ultimate tensile strength (UTS), yield strength (YS), elongation to fracture (EI) and the quality index (Q) of T6 treated eutectic Al Si die alloys alloying with 3.6 wt.% Mg and 0.5 wt.% La can reach 312 MPa, 270 MPa, 4.28% and 406 MPa respectively, and the enhanced mechanical properties corresponding to the evolution of the microstructure.

Meanwhile, Global load sharing (GLS) model was employed to compare with the experimental mechanical properties and corresponding fracture mechanics model was employed to analyze the fracture behavior.

Crushed air-cooled slag can be used to produce a high-strength concrete with better mechanical properties than corresponding concrete made with crushed hematite and ilmenite.

This suggests that multiple methods of post-growth modification of CNT arrays can achieve densified turfs with tailored mechanical properties without corresponding degradation of the electrical contact behavior.

It resulted in a rapid reduction in mechanical properties for corresponding composite rods owing to the weakening of interfacial binding capacity between poly-lactic acid and inner layer.

Results showed that although increasing Vf resulted in a ∼27% reduction in the mechanical properties, the corresponding improvement in the self-healing potential was significantly higher.

The rate of degradation was found to be controlled by both the oxidation and the ratio of high to low MW alginates, as monitored by the reduction of mechanical properties and corresponding number of crosslinks, dry weight loss, and molecular weight decrease.

And, mechanical properties and corresponding material parameters of the paper depend strongly on the fibrous structure of the paper sheet, which in turn, has been determined by fluid dynamics in the beginning of the papermaking process, in the headbox.

Researchers have made a study about the enhancement of dental composites using certain glass fibers (with diameters of about ten microns) [ 24]; however, mainly because of poor interfacial adhesion, the mechanical properties of corresponding dental composites were indeed increased but finitely.

The results show that, as expected, cement mortars always have better mechanical properties than the corresponding cement lime mortars.