Sentence examples for mechanical power generated from inspiring English sources

From CFD case studies, guiding and throttling effects of the wind booster are able to increase angular speed of a VAWT which leads to increase in mechanical power generated from a VAWT.

The ChipSystem consists of three interconnecting parts: a microchip in the handle that reduces vibration; a FlexCircuit that transmits power from the chip to the racquet; and the Intellifiber, which converts the mechanical power generated by the impact with the ball into electrical energy.

From the above equations, the mechanical power generated by the motor is ({T_{mathrm{m}}}{omega _{mathrm{m}}}), and the motor efficiency ({eta _{mathrm{motor}}}) is begin{aligned} {eta _{mathrm{motor}}} =frac{{T_{mathrm{m}}}{omega _{mathrm{m}}}}{{V_{mathrm{a}}}{i_{mathrm{a}}}} end{aligned} (8).

The new modified Savonius rotor and the conventional Savonius with the same Aspect Ratio have been tested in an open jet wind tunnel in order to verify the influence level of product design parameters on rotor performance, in terms of power coefficient, torque coefficient and mechanical power generated.

Their additional values from in situ performances are mainly due to real time feedback of mechanical variables as the external power generated by athlete at one (or more) contact with the ergometer (e.g. handle power while rowing an ergometer).

The block diagram of the SFR model is shown in Fig. 3 where P d, P m, H, D, R, F H, T R, and K m are disturbance, mechanical power, inertia, damping, droop, fraction of total power generated by high-pressure turbine, time constant of reheater, and mechanical power gain factor of the aggregated system.

The equation of motion, and electrical power generated are derived in terms of design dimensions and mechanical properties of the wave energy converter.

Sun et al. [14] indicated that the nanorod of PMN-PT are good candidates than bulks in mechanical energy harvesting due to their high strain tolerance and the larger output power generated by PMN-PT.

Active cooling of thermoelectric generators (TEGs) is problematic since mechanical devices such as pumps and fans draw a high proportion of the limited power generated.

In nearly all mechanical power applications in the oil and gas industry, it is necessary to transmit the power generated by a prime mover to an operation.

Power generated in Texas stays in Texas.