Sentence examples for mechanical axis to from inspiring English sources
Post-operatively, the recommended follow-up was at 3-month intervals until correction of the mechanical axis to neutral was achieved, whereupon implant removal was undertaken.
The current work has shown that, using the CORA method, executing a FDO for an epiphyseal CORA and realigning the mechanical axis to the knee centre can achieve deformity correction even when fixed using plate and screws.
This bending moment (load × moment arm) gives rise to the deformation; the moment arm of the load is the distance from the line of action of the load (mechanical axis) to the neutral axis of the bone and plate.
Deviation of the mechanical axis to the affected compartment was a criterion for performing a high tibial osteotomy (HTO).
The goal of alignment was to correct the postoperative mechanical axis to within 3° of neutral, and all component angles to within 3 degrees of the ideal.
Fujisawa, Masuhara and Shiomi used a different approach, aiming for the mechanical axis to pass through a point 30%to40%0% lateral to the midpoint of the knee (the so-called Fujisawa point).
The purpose of this prospective, randomized study was to determine whether this iAssist system enables the surgeon to make more accurate bone resections and better restore the mechanical axis compared to conventional instruments in TKA.
Mechanical perturbations, such as force, affect the mechanical transitions of the enzyme by tilting the landscape around the chemical axis to a first approximation, while chemical perturbations, such as [NTP] and [PPi], rotate the landscape around the mechanical axis, again to a first approximation.
The long, standing radiographs at the time of follow-up were analyzed for the mechanical axis according to Stevens et al. (2004), for the mechanical axis deviation (MAD) referred to the center of the knee joint, the lateral distal femoral angle (LDFA), and the medial proximal tibial angle (MPTA).
The point at which the new mechanical axis was to cross the lateral tibial plateau was decided using the method described by Jakob and Murphy [33] (Fig. 2).
The anatomic axis measured from a standard weight-bearing knee radiograph is a more readily undertaken substitute for measuring the mechanical axis compared to a full limb radiograph [ 6, 7].
