Sentence examples for mechanical anchorage of from inspiring English sources

The observed pullout load-slip curves of hooked end steel fibres embedded in UHPM is generally characterised by a steady increase up to peak load as a result of the combination of two mechanisms which are: detachment of the fibre-matrix bond and mechanical anchorage of the end hook.

Metallic porous materials are designed to allow the ingrowth of living tissue inside the pores and to improve the mechanical anchorage of the implant.

Conventionally, surface degreasing (applying solvents to remove organic impurities) and grit blasting (corundum) are carried out as a two steps pretreatment prior to the thermal-spraying operation to guarantee a mechanical anchorage of the molten particles to the substrate.

This could be ascribed to comparatively lower strength matrix and higher mechanical anchorage of end hook fibre.

Consequently, a close and tight fit between the graft and the residual acetabulum in addition to mechanical anchorage of the cage to the viable host bone is critical to the successful outcome of the reconstructive procedure [ 18, 21].

By interconnecting ECM proteins to cells, collagen XVI is likely to be able to move these proteins and hence affects ECM networks, ensuring mechanical anchorage of the cell and outside-inside signal transduction [ 85- 86].

Different prestressing and anchoring procedures are investigated: (i) post-tension, with mechanical anchorage on the ends of the wood elements; (ii) pre-tension, with the anchorages being either mechanical, as in the previous system, or glued, with the force being gradually transferred through shear stresses along a certain length of the wire/wood interface.

Furthermore, mechanical anchorages of steel plate strips and bolts were added to the laminates in one frame of these specimens.

A mechanical anchorage device consisting of a hollow metallic cylinder with two-piece anchor wedges was installed at the front of the pressure cell (see Details A and C in Fig. 3).

On the other hand, the amount of mechanical anchorage is reduced if a large amount of shrinkage occurs during solidification of the particles (Heimann 2006).

In each block a single CFRP laminate was mounted using the EBR technique and mechanically fixed to concrete through a commercial mechanical anchorage with different levels of transverse compression.