Sentence examples for measures where a from inspiring English sources

Such double negatives are often asked in surveys, as Professor Don Dillman points out in his textbook on Mail and Internet Surveys, because of elections where voters are asked "to vote for measures where a yes vote would result in something not being done," just like the Gallup repeal question.

The same calculation can be performed for measures where a decrease in value represents improved performance.

Leaf-level transpiration (E, mmol H2O m−2 showedhowed patterns similar to those reported for other gas exchange measures, where a site-specific quadratic pattern was apparent for E over the growing season, regardless of ecotype (P = 0.002).

The item reduction procedures were described in detail for the measures where a stated psychometric scaling strategy was followed, illustrating the advantage of using a psychometric scaling method with an explicit predefined methodology.

In addition to the proportion of cells stained, the saturation of the stain is also measured, where a deeper stain indicates a greater intensity of the receptor.

For a consistent experimental paradigm, scalp positions and latency were measured where a negative component was observed, and it is assumed that the present component in the chimpanzee was similar to the human MMN.

Discrimination was measured by the commonly used area under the ROC curve measure, where a value of 1 suggests perfect discrimination and a value of 0.5 suggests no discrimination.

Using the DASH as the primary outcome measure, where a difference of 15 points is considered to be a clinically important difference a total of 51 patients will be needed in each group for a power of 90%.

Using the DASH as the primary outcome measure, where a difference of 15 points is considered to be a minimal important change (MIC) [ 16] and using a between-group standard deviation of 22 points [ 17] a total of 51 patients would be needed in each group for a power of 90%.

Using the DASH [ 14] as the primary outcome measure, where a difference of 15 points is considered to be a clinically important difference [ 16] and using a between-group standard deviation of 22 points [ 18] a total of 51 patients would be needed in each group for a power of 90%.

Additionally, to get a measure where a possible effect of the different length of day (9 h) and night (15 h) milking intervals, respectively, and of different milk volume (dilution/concentration effect) could be minimized, the average output per time unit (output/hr) since the previous milking of each parameter was calculated and tested.