The purpose of this paper is to examine and synthesise the literature on alternating pressure air mattresses (APAMs) as a preventive measure for pressure ulcers.
For complete condensation analysis, pure steam was supplied to the test section and heat transfer properties were measured for pressure from 100 to 280 kPa.
As shown in Figure 1, these three sites were measured for pressure pain threshold using a pressure algometer: Site A is the assumed A-TrP site, Site B is the assumed MTrP site, and Site C, the muscle-tendon junction site, acted as the control site.
The phase composition and density and viscosity of saturated liquid phase were measured for pressures up to 10 MPa.
Data were measured for pressures up to 14 MPa and over a temperature range from 278 to 370 K.
The two-phase pressure drop and the liquid hold-up (liquid RTD determination) were measured for pressures up to 8.1 MPa.
Cavanagh et al. (1997)[ 38] suggested four radiological measures for peak pressure in the MT-1 region.
Main Outcome Measures: Correlations between sensor output and criterion measures were determined for pressure and temperature data.
The phase composition and saturated density of liquid phase were measured for each pressure.
The phase composition, saturated density, and viscosity of liquid phase were measured for each pressure and temperature.
