Sentence examples for measurements to avoid from inspiring English sources

A single examiner (EO) performed measurements to avoid interobserver error.

If the ADC map is of low quality or if the lesion cannot be clearly defined, we suggest refraining from taking ADC measurements to avoid false-negative results.

A minimal laser power of 2 mW was used during the measurements to avoid any damage or heating of the carbon films.

Besides, an effective sampling scheme is needed to multidimensional signal reconstruction using a low number of measurements to avoid all redundancies.

After calibration, the resolution of the nuclear images and the multimodality co-registration error were evaluated with a different set of point source measurements, to avoid using the same measurements for calibration and evaluation.

However, the presented results are important not only for clinical daily use, where the EPT setting should be preferably used if scanning implants, but also for safety test measurements to avoid false underestimations of heat induction around metallic objects when are conducted with EPT instead of CPT.

Fish were starved 24 h before each measurement to avoid inclusion of ingested feed in the weight measurements as well as to minimize stress.

In this paper, we propose an information push-delivery system, which applies fuzzy information retrieval and fuzzy similarity measurement to avoid the information overload problem.

On each sampling occasion, leaf respiration rate [RD, μmol (CO2) m-2 s-1] measurements were carried out contemporary to PN ones (on the same leaves) by darkening the leaf chamber with a black paper, according to Cai et al. (2005), for 30 min prior to each measurement to avoid transient post-illumination bursts of CO2 releasing (Atkin et al. 1998a, 1998b).

The special cases and should be treated separately: the first one implies that u belongs to the disk, while in the second case we can either assume that the node lies in the exterior of a circle or, as suggested in [11], simply discard the measurement to avoid unbounded regions.

The gain of the photodiode amplifiers was reduced during this measurement to avoid saturation.