Sentence examples for measurements of aggregate from inspiring English sources

Accurate measurements of aggregate volumetric properties are essential to a satisfactory mix design and successful production of pavement.

In addition, AIMS 2 was shown to provide more direct and scientific measurements of aggregate morphological characteristics that present higher correlations with the mixture performance than traditional methodologies.

In this paper, we investigate an intermediate architecture, where smart circuit breakers provide measurements of aggregate power consumption at room (or section) level granularity.

Because measurements of aggregate productive inefficiency require comparative analysis, they indicate how an area is performing with respect to welfare relative to the highest level of welfare in China.

Measurements of aggregate geometry and the force of resistance to the compressive force were then utilized in the Young-Laplace equation [42], producing numerical values of apparent tissue surface tension.

These measurements are then applied to the Young-Laplace equation [ 26], generating measurements of aggregate cohesion, otherwise expressible as tissue surface tension.

Parallel to this, density measurements of aggregates with a diameter of 8 10 mm were made at a matric potential of −6 kPa.

The presented study has highlighted the need for accurate measurements of aggregates' and minerals' specific surface areas and (hence) requirements to develop new approaches to resolve problems associated with BET-based methods.

TST measurements of aggregates of the Dunning lines reveal that JHU-3 and AT-2 are significantly more cohesive with surface tensions of 9.9 ± 0.6 and 13.1 ± 0.5 dynes/cm, respectively, than those of MLL with a σ of 3.2 ± 0.3 dynes/cm, as compared by ANOVA (p < 0.0001) and Tukey's MCT (Table 1 and Figure 1A).

Filtered micro-texture profiles were obtained from scanned height profiles and subsequently two parameters, root mean square roughness (Rq) and depth of surface smoothness (Rp), were calculated as quantitative measurement of aggregate surface friction for all sub-bands of wavelengths.

In those studies, measurement of aggregate cohesion was performed under conditions in which α5 integrin expression and the amount of sFn were kept constant.