Sentence examples for measurement process for from inspiring English sources
In some countries, health technology assessment involves a measurement process for safety and efficiency [9].
The preparation and measurement process for all samples are the same conditions.
This paper documents the findings of experiments done to assess the capability of a photogrammetric measurement process for use in a metrology assisted robotic machining application.
In this scheme, the system performance is typically analyzed using three sub concepts, if it is performing a service correctly: 1) responsiveness, 2) productivity, and 3) utilization, and proposes a measurement process for each.
Here, ΔT refers to the temperature difference measured at the sensing region under certain heating power and usually it takes around 20 s for temperature to stabilize and the whole measurement process for each data point takes 1 2 min.
Figure 4 represents a basic diagram of the frame formats and the channel measurement process for the APs in a typical ith network, AP2 and two clients, each from the ith and jth networks.
Based on this motivation, we present in this work the design of a data-driven tracking system that integrates computational and measurement processes for optimized operation and reliability on mobile devices.
This pilot study was performed to test the applicability of the measurement process of quality for HPV vaccination centers by a multidisciplinary team: the QuaVaTAR group.
ISO 5725-2 dethelstandardapproachpproach used in measurement science to characterize measurement precision for a specific measurement process from the results for a single material in a single study [ 9, 12].
Since there is only a single set of measurements in the experiment (as opposed to the Monte-Carlo runs where a different realization of the measurement process is generated for each run) and since the results of the particle filters hardly differ for different runs, only 10 Monte-Carlo runs were found to be trustable.
This measurement process is repeated for several source positions to obtain a data set that is used for the reconstruction of the fluorochrome concentration.
