Sentence examples for measurement points when from inspiring English sources

Both inter- and intra-agreement was worse for the TT/3R method most likely due to difficulties in defining the same measurement points when re-measuring the diameters.

Rates of restoration at respective measurement points when the load was controlled at points A to E are listed in Figure 8.

This approach does not capture fully the interplay of time and measurement points when longitudinal data are available [ 38].

Figure 4 shows the impact of the failure to identify the unworn surface accurately and Figure 5 shows the distribution of the measurement points when such an error takes place.

If rash occurred, we attempted to collect CK measurements at time points when the rash resolved, if documented.

It demonstrates a significant improvement on the accuracy and reliability of damage identification results when the measurement points and mode are determined according to the present technique.

Results show that although the mean pressure coefficient decreases as the area density increases and when the measurement points are located at the downstream side, the fluctuating component increases significantly, giving larger maximum and minimum coefficients than those for an isolated building.

These findings are evaluated in light of previously published studies of TAM sensitivity, and special attention is given to Gordis's theory, which suggest that TAM sensitivity is related to the natural frequencies of the structure when all measurement points are fixed.

As expected, TIAC accuracy reduces considerably (i.e., larger RDs) when fewer measurement points were taken into account in combination with parameter values derived using the standard approach.

STM without considering the directional antenna pattern (i.e. assuming omnidirectional transmission) in general outperforms other methods up to approximately 400 measurements, but it is outperformed by IDW2 and Kriging, when more measurement points are available.

We suggest that future studies allow for several measurement points to investigate this relationship when using technology-based methods.