Sentence examples for measurement intersection from inspiring English sources

In cases for which performing measurement intersection or Mahalanobis distance minimisation is problematic/impossible, initial candidate locations should be randomly sampled within the surveillance region.

We considered the radiographic measurements the most important because these provide a clinical guideline, while the CT measurements were made to verify the radiographically measured intersection angle and determine the course of the intersection.

Details of gap/lag measurement at intersections can be referred to in [29].

Figure 7c, d are examples of valid measurements: the intersection of their graphs would show that the system under test has a crossover frequency at approximately 1,550 Hz.

Figure 15 shows the resulting received power when configured same as our measurements in intersection 10 with tx↔center distance d t = 30 m.

In order to maximise the probability that the correct DDOA intersection will be determined, X 0 is set to be the point of intersection of the two corresponding AOA measurements (if AOA measurements are also generated by the two sensors, and these measurements intersect).

In the context of typical experimental measurements at intersections and roundabouts, the analysts often need data which should be qualitative and/or quantitative: the qualitative data are usually considered descriptive and can result subjective in comparison to the quantitative data that are gathered in an experimentally repeatable manner.

The average ion drift measurement at the intersection of the footprints of the satellite orbit and the HMB determines the offset used to correct the Swarm data.

For representation purpose, we locate the TEC measurement at the intersection of the line-of-sight and an ionospheric thin layer whose height is chosen near the peak of electron density, here 250 km.

The experimental measurements at the intersection of steel rebars were found to be mostly higher than the areas between them.

Measure the middle of your sheet of plywood by taking a measurement to determine the intersection between the midway point of the length and midway point of the width of the table.