Sentence examples for measurement initially from inspiring English sources

For performing software measurement, initially, an organization must plan it.

For the knee flexion measurement, initially the hip was at zero degrees of extension, abduction, and adduction, but as the patients maximally flexed the knee, the hip also flexed.

During this phase, satellite data processed by MIROVA exhibit very few thermal alerts, whereas ground-based measurements initially were fluctuating around 1 MW, and then progressively decreased toward their minima.

As an example the initial round of the multi center/method ESCOT study for 8 hydroxy 2'deoxyguanosine measurements initially returned values differing by a factor of 1000 with the higher values resulting from source artifacts in a gas chromatography-mass spectrometry (GCMS) method.

The measurement consists initially, in immobilizing alpha emitters in the form of insoluble hydroxides onto the entrance window of an immersed alpha particles detector.

Power-ramping experiments, with in-situ surface temperature measurement, were initially carried out to assess surface temperature effects on treated layers.

This method is a modification to the measurement method initially used by Schroll et al. (2009).

The variances of the two methods factors were constrained to be equal because the procedural similarity in the measurement series initially led us to suspect that routine within-series laboratory variations might propagate proportionally.

After correction of the paraproteinemia with successive therapy of melfalan-prednisolon and later bortezomib-dexamethason, cholesterol levels restored to initial values HDL-C measurements were initially performed on a Hitachi 917 analyzer (Roche Diagnostics, Switzerland) with HDL-C reagent (HDL-C plus second generation, Roche Diagnostics, Switzerland).

Overall, 660 measurements were initially performed, of which 47 were discarded following off-line analysis while still blinded, leaving 613 measurements for inclusion in the study.

Analysis of results involves combination of measurements on initially amorphous and on semicrystalline (annealed) samples.