Sentence examples for measured values shows from inspiring English sources

The statistical behavior of these measured values shows that the fault resistances are moderate in a high percentage of cases.

Although a direct comparison of the measured values shows that the maximum deflection observed by Trichet et al. was 0.84 ± 0.03 μm, whereas we measured a maximum deflection of up to approx. 1.8 μm on both antagonists, this was only observed in very few instances.

Results: The ratio of the maximum-to-minimum measured values shows that 2- to 3-fold differences occur in distance, area, or volume measures of continence system morphologic features.

The comparison to the measured values shows that a quantitative interpretation of the limiting current measurements depends on the ability to obtain sufficiently exact information about cell geometry, diffusion coefficient and inlet concentration.

A mathematical estimation of the seeding influence (on the impurity concentration within the outer pastille layer) compared with measured values shows, that the seeding itself does not decrease the impurity concentration in the outer layer obviously.

The comparison between the three methods and the measured values shows that the Angstrom-Prescott model gives the best estimation of the global solar radiation for the cities of Mongo.

Comparisons between simulated and measured values showed a good agreement for temperature and humidity.

Comparison of calculated interdiffusion coefficients with experimentally measured values show acceptable agreement in Ni-rich alloys but poor agreement in Al-rich alloys.

Self-report and measured values showed good agreement (r > 0.9) (21).

Measured values showed an increase between 1998 and 2002, 38.9% to 42% and a decrease to 39.5% in 2007.

The dissimilarities between the measured values shown in Fig. 7 and values generated from the model can also be attributed to experimental limitations such as the light beam positioning, which was done manually by visual inspection.