To map the minefields, Mr. Willoughby said, the Halo Trust teams conducted topographical surveys using equipment that measured standard latitude and longitude measurements.
We measured standard lengths, defined as the measurement from the anterior-most tip of the jaw to the posterior-most tip of the notochord (early larvae) or hypurals (later) to ascertain growth rates (see also [31]), avoiding unnecessary use of anesthesia in order to limit growth retardation.
The measured standard deviations for these outlier points are valid sample measurements of the variance process and should be used to calculate the pooled standard deviations for spots with similar intensities.
The measured standard deviations for the outlier points were considered to be valid sample measurements of the variance process and were not excluded from the calculation of the pooled standard deviations for spots with similar intensities.
The experimentally measured standard electrode potential of an element is related to fundamental elemental properties through a thermodynamic cycle.
Varying the material properties with the measured standard deviation between specimens leads to an average change of ±17% in the maximum and minimum principal stresses.
The measured standard deviation in the log of the fatigue life was 0.105, which is greater than the value obtained for the 7050 alloy, but not significantly so.
The number of subjects required for study entry, depends on the following four concepts: 1) The magnitude of the hypothesized effect (i.e., how far apart the two sample means are expected to differ by); 2) the underlying variability of the outcomes measured (standard deviation); 3) the level of significance desired (e.g., α = 0.05); 4) the amount of power desired (typically 0.8).
The measured standard deviation around each data point (mass and element flows) are used in the least-square fit to reconcile the mass balance around each individual unit operation in the plant as well as over the total flow sheet, within the statistics of the collected data.
The measured standard deviation of the log of the fatigue life was found to be 0.138, which is significantly higher than that obtained from the 7050 alloy, and noticeably higher than the value of 0.10 used in determining safe life limits for aircraft aluminum components.
The scheme shows uniform convergence among all WUs with a measured standard deviation of their CW sizes being less than 1.5%.
