Sentence examples for measured samples have from inspiring English sources

The physical and electrical properties of the measured samples have been described.

All measured samples have a maximum mass loss below 0.3% for 560°C (maximum working temperature of solar salt) and below 8% for 700°C, showing the stability of the salt-based nanofluid at high-temperature conditions.

The measured samples have a quite low correlation coefficient between δ13CPDB and δ18OPDB (r = 0.46) which would imply a generally open setting, where fresh sea water was commonly introduced.

Between operators, certain parts of the experimental set-up were different: i.e., the measuring samples had been removed and reinstalled and the environmental conditions were slightly different.

Although a large database with recently measured samples would have been preferable, such a database was not readily available, due to the lack of lactate measurements conducted in recent studies.

Some of the limitations of this study include the small numbers of measured samples which has not allowed us to relate the findings directly to clinical information and stroke characteristics such as infarct size, extent of recovery, association with time of survival and survival.

When genotypes are also measured, FFPE samples have substantially lower call rates (suggesting a loss of performance) and genotype discordances between FFPE and fresh frozen samples raise troubling questions about data reliability [ 5- 10].

Levels of polybrominated diphenyl ethers (PBDEs) measured in human samples have increased in recent years, but the health effects of these compounds are not well studied.

While a temperature-sensing WSN could probably take a reading every minute and not lose accuracy, to measure noise, sound samples have to be taken.

The data suggest that the age group 5 17 years, which had a measured sample prevalence of zero, likely has a significantly lower prevalence of hypoxemia than the other two age groups (see Fig. 2).

Subsequently, magnetometer sensor response over the cross area of the measured sample (typical u-channel has a cross area of ~1.8 × 1.8 cm2) needs to be calculated using the collected sensor response measurements.