Sentence examples for measured frequency is from inspiring English sources

Experimentally, an annular high frequency resonator was measured to have its fundamental resonance mode at 2.75 MHz with a quality factor of 6. Discrepancy between design and measured frequency is due to fabrication process errors and dynamic coupling error.

If the measured frequency is different for each load, then the calculations would be performed and applied for each REF individually.

The measured frequency is observed to decrease linearly with an increase in the number of ions, as has been reported previously for space-charge effects between ions of different mass-to-charge.

Compared with other vibration based methods, the proposed method is fast, sensitive and feasible to implement in practice as the measured frequency is more accurate than the mode shapes, and only a single accelerometer is required in the tests.

A stable signal-to-noise ratio (SNR) about 80 dB with a noise floor at 0 dB can be realized at 30 Hz and a 0.5 Hz resolution can be observed ranging from 10 to 50 Hz of low-frequency acoustic wave (The relative error of measured frequency is lower than 1%).

It is important to note that all calculations and estimations that will be presented are the same for each REF and refer to the aggregation as a whole, because it is assumed that the measured frequency is the same for all loads; therefore, the subscript i is not used.

Since the measured frequencies are in good agreement with previous results, we believe that the bulk of our sequences represent bona fide 3'-processing sites.

The measured resonance frequency is measured about 10 MHz, which is shifted to lower frequencies by increasing the ambient pressure.

Measured frequency values were converted into strain values by multiplying gauge factors and also compensating for atmospheric temperature variations.

The lowest measured resonant frequency is 501 Hz in a lens component with two connectors.

The difference between modeling and experimentally measured resonance frequency is attributed to the error in exactly manufacturing tuning fork tine width by photolithography.