Ai Feedback
Exact(23)
Therefore, the ultimate target of measure phase was to establish a good measurement system to measure the process performance.
The learners were required to observe and conclude if there was any meaningful information from the "Analyze" phase after assessing the measurement error or shooting capability baseline in the "Measure" phase.
They observed that this last measure phase contains structural information that contributed to improving the classification.
Setting improvement targets present sigma level for filling process was as worked out during Measure phase.
Some authors used HT to measure phase synchrony between two signals [37, 38, 40].
For this specific case, two modules are selected, NI 9225 and NI 9227, to measure phase voltages and currents, respectively.
Similar(36)
Because these stations are approximately located at the opposite direction of faulting, the rupture directivity reduces significantly the observed amplitude of Rayleigh wave to make it difficult to measure phase-velocity due to the problem of phase-skip, especially for the short-period surface waves.
The blue line corresponds to the measured phase confined to the ±π interval and shows that a single measured phase value corresponds to multiple elevation angles.
Finally, predicted and measured phase jitter showed good agreement.
Fig. 3 Reference and measured phase velocity dispersion curves.
The measured phase errors are shown in Figure 9.
Write better and faster with AI suggestions while staying true to your unique style.
Since I tried Ludwig back in 2017, I have been constantly using it in both editing and translation. Ever since, I suggest it to my translators at ProSciEditing.

Justyna Jupowicz-Kozak
CEO of Professional Science Editing for Scientists @ prosciediting.com