Sentence examples for measure adsorption from inspiring English sources
In this paper, several important methods to measure adsorption equilibrium data are discussed and evaluated.
A solution of BPA 5 mg/L + TiO2 10 mg/L was used to measure adsorption kinetics.
The support materials were characterized by different methods, in order to measure adsorption sites on the surface.
In this work FA was used to measure adsorption isotherms of three components as single solutes and in binary and ternary mixtures in a reversed-phase system.
The measured adsorption capacities correspond to those expected from their structures and chemical properties.
The aim of the experiments is to predict mass transfer diffusivity and breakthrough curves from the measured adsorption isotherm.
This improvement was followed by MMC2 for measured adsorption uptake and breakpoint about 8.74 and 9.47%, respectively, comparing with the base adsorbent (MIL-100(Fe)).
The relative error between the predicted and the measured adsorption isotherms increases as the absolute difference in the kinetic diameters of the reference and test adsorbates increases.
The effects of Ti/Si molar ratio and of the mesoporous silica structure were investigated measuring adsorption capacity and photocatalytic degradation of toluene.
A new technique for measuring adsorption on non-noble metals is presented here on the basis of former experimental results and experience.
The chitin and OSP characteristics were consistent with the classical linear and Freundlich isotherm models of adsorption, with the measured adsorption coefficients ranging from 40.46-64.24 μg/kg for chitin and 46.65-54.70 μg/kg for OSP.
