Sentence examples for mean velocity for from inspiring English sources

Objective: The purpose of this study was to assess the value of the middle cerebral artery time-averaged mean velocity for the detection of anemia as the cause of fetal hydrops.

The mean (z score) of middle cerebral artery time-averaged mean velocity for fetuses with normal hemoglobin was 1.1 ± 0.81 and for the fetuses with anemia was 4.71 ± 2.16 (P <.001).

The purpose was to evaluate the concurrent validity of derived center of pressure (CoP) excursion and mean velocity for the raw CoP coordinates produced by the BTrackS and FP during feet together quiet upright stance.

Results common to all three lattices are (1) the BGK relaxation time τ must be greater than 12 corresponding to positive shear viscosity, (2) there exists a maximum stable mean velocity for fixed values of the other parameters, and (3) as τ is increased from 12 the maximum stable velocity increases monotonically until some fixed velocity is reached which does not change for larger τ.

Fig. 5 Comparison between the Takahashi (1991) measured mean velocity and the computed RASH3D mean velocity for the sectional reaches shown in Fig. 4. a T: Turbulent rheology; b V: Voellmy rheology; c B: Bingham rheology; d F: Frictional rheology.

The mean velocity for a Newtonian fluid such as water or brine is described by Turcott and Schubert (1982) v = frac{{w^{2} }}{12 mu }frac{Delta p}{Delta x} (1 which is very similar to the form for flow in a capillary of diameter d used in the experiments described later.

We report that the mean velocities for each experiment vary greatly, depending on the lanes contained in the measurement section.

Table 2 lists the number of slow and fast vehicles in a network with two classes of mean velocities for different choices of mean velocities.

It is a very simple and low-cost device used to measure mean velocities for various industrial purposes (Bryant et al. 2014; Graham et al. 2013; Oh and Lee 2011).

The demonstrator's mean velocities for each experimental condition are reported in Table 1 (columns HI and HE).

Data points are the mean velocities for all measured traces at each force (N = 54).