Sentence examples for mean spectrum was from inspiring English sources

A mean spectrum was then taken of the areas of calcification from the spectral image map, and used for calculation of amide: phosphate ratios and for partial least square calculation of carbonate content (see Figure 1).

In ROI with corresponding negative w1 values, the opposite mean spectrum was used to identify peaks, that is the mean spectrum derived from the spectra for the group with binary response 0. As the high mass regions of all protein profile curves displayed a large amount of small amplitude noise, they were smoothed before peak detection using a five point adjacent averaging algorithm.

Existing heuristic methods select and/or scale ground motion records so that their mean spectrum is close to a target/design design spectrum.

After appropriate scaling, mean spectra are computed both irrespective of, as well as for each different, ground condition, and comparisons with EC8 provisions are made.

Peak assignments of these mean spectra were also identified.

These mean spectra were further averaged to yield strain and organ specific ATR-FTIR reference spectra.

Four consecutive measurements were accumulated and the mean spectra were recorded.

So, the mean spectra were segmented using various sizes (4 to 73 nm) and the piece to piece correlations were calculated at these different scales.

After these correlations were made, mean average spectra were calculated for each cluster, and those that described artefacts from dispersion were subsequently removed from any further supervised analysis.

Mean power spectrum was calculated on the basis of the average time-frequency analysis result.

For every tissue sample, a mean ATR spectrum was obtained.