Sentence examples for mean size value from inspiring English sources

As already described, for each nanofluid, the mean size value was obtained, repeating the measurements almost every day for 30 days, both for the nanofluid stored in static mode and for the same nanofluid after mechanical shaking.

Since the mean size value of the NPs shown in Figure 1a is smaller than the Bohr's diameter of the exciton in bulk SiC substrate (approximately 5.4 nm), they exhibit highly efficient luminescence with energies higher than the bandgap energy of the bulk SiC substrate due to spatial and quantum confinement effects [13, 14].

Model E has the same height of peak amplitude, but its pore size distribution is not continuous and the mean size values of the peaks are very different.

Although some established techniques have been demonstrated to provide consistent measurements between mean size values in round-robin exercises [e.g., ASTM Standard E2490-09 (ASTM 2009)], the vast majority of these studies (including ASTM E2490-09) have utilized model materials that exhibit narrow size distributions.

Similarly, data about EPs hysteroscopic size showed no difference between the groups despite the fact that we found a mean hysteroscopic size value bigger than the mean sonographic size (Table 1).

It is observed that the mean nanoparticle size value of the distribution first increases with an increase in the Ar flow rates to finally decrease for higher Ar flow rates.

The results are given in the form of the mean effect size ("Value") and their corresponding standard error ("SE") as a measure of uncertainty and the p-values of each explanatory variable.

In contrast, a random effects model assumes that each study estimates different, yet related, true effects and that the distribution of the various effects is normally distributed around a mean effect size value.

Capability of the developed neural network models as well as multivariate regression models is determined by comparing predictions with measured mean particle size values and predictions based on one of the most applied fragmentation prediction models appearing in the blasting literature.

The maximum, minimum, and mean diameter size values of the inorganic particles are listed in Table 1.

Small MLGS (mean largest grain size) values indicate increased IRI activity.