Sentence examples for mean rotation angle from inspiring English sources

During mechanical loading, all four grains rotate and the mean rotation angle increases with austenite deformation.

An innovative method, Mean Rotation Angle (MRA) is utilised for post-processing of evolving stress data at the vicinity of the fracture tip.

After the C correction, however, the mean rotation angle of the apex did not change significantly (17.6 ± 4.2, p = 0.209).

The mean rotation angle at the apex measured on patients' post-surgical CT images was between the mean values obtained by the simulated C correction and the simulated C + D correction.

For the pelvis the ICC of the mean flexion-extension angle varied between 0.66 and 0.83, the mean lateral flexion angle between 0.16 and 0.81 and the mean rotation angle between 0.40 and 0.62.

As for the three-dimensional motion variables for the torso the ICC's of the mean flexion-extension angles range between 0.65 and 0.93, those of the mean rotation angle between 0.80 and 0.82 and those of the mean lateral flexion angle between 0.49 and 0.67 (table 2).

The CT scans obtained after the patients' posterior correction and fusion surgery with a segmental PS construct revealed a mean kyphosis angle of 12.0 ± 7.4, a mean radius of curvature of 896 ± 373 mm, and a mean apical rotation angle of 8.4 ± 4.5.

The mean vertebral rotation angle at the apex was 15.2 ± 5.5 before the simulated correction, and it was 0 (completely corrected) after the C + D simulation.

The sine curve② is sin(2πf θ t) and with a slope is 2πf s  = tan ≫ 1, which means the rotation angle value is φ > 45°.

The exceptions were step width (SEM 10% of between day mean), left foot rotation angle (SEM 14% of between– and within day mean) and right foot rotation angle (SEM 11% of between– and within day mean).

The mean preoperative apical rotation angle of 15.2 ± 5.5° was completely corrected after the C + D method (0°) and was unchanged after the C method (17.6 ± 4.2°).