Sentence examples for mean ridge height from inspiring English sources

InFuse™ treatment resulted in a mean ridge height increase of 27% ± 31, significantly lower than the B-247 formulation (p < 0.0001, data not shown).

The mean ridge heights on fractured surfaces are found to correlate with the toughness of the BMG.

However, the minimum runoff occurred at a ridge height of 6.7 cm, and the maximum sediment yield at a ridge height of 12 cm.

The FE results were surveyed in combination with the ridge height reductions, along the mesio-distal direction.

The follow-up panoramic radiography showed a good alveolar ridge height without bony resorption (Fig. 3c).

The canal height (CH) and ridge height (RH) were measured on para-axial cut using a digital caliper.

Ridge height of approximately 1.3 μm was obtained before the pulsed anodic oxidation (PAO) process.

The alveolar bone defect in this case was the loss of ridge height with normal ridge width, class II according to the Seibert classification [20].

Good alveolar ridge height without bony resorption was achieved at 18 months after socket preservation surgery (Fig. 1i).

There are not significant differences found when the anterior alveolar ridge height and anterior dentoalveolar height were measured, p > 0.05(Table 3).

Type I was more than 75%% of the alveolar ridge height, type II was 50 to 75%% of the alveolar ridge height, type III was less than 50%% of the alveolar ridge height, and type IV has no continuous bony bridge.