Sentence examples for mean force coefficients from inspiring English sources

Also presented are the mean force coefficients and Strouhal numbers on rectangular cylinders.

Model scale mean force coefficients obtained in the wind tunnel and available in the literature tend to overestimate those from the full scale tests.

Mean force coefficients for level 8 are always higher than all the other levels due to edge effect at top levels.

Results are presented for the mean force coefficients, surface pressure coefficients and Strouhal numbers on a square section cylinder at varying angle of incidence.

The results show considerable changes of the mean force coefficients with Reynolds number ReD and spin parameter SP, which can be attributed to the altered boundary layer separation.

Mean force coefficients for various cladding arrangements are reported for models of a 10-storey structure for two plan aspect ratios (1 1 and 3 1) in smooth, grid turbulent, and boundary layer flow.

As the Reynolds number increases, the Strouhal number, the mean force coefficient and the RMS of coefficients increase, and they all show the same variation tendency.

Mean wind force coefficients for the entire scaffolding and area-averaged wind force coefficients were determined for different scaffolding geometries.

Effects of neighboring building location, neighboring building height ratio and principal building opening ratio were studied, and mean panel force coefficients were determined.

When the neighboring building was located in front of the measured scaffolding, the interference effects on both the largest positive and largest negative mean panel force coefficients were dramatic.

The neighboring building height ratio had significant effects on the largest mean panel force coefficient but only slight effects on interference factors.