Sentence examples for mean drag force from inspiring English sources

It is concluded that tapering or set-back helps to reduce the mean drag force and the fluctuating lift force.

The magnitude and the phase of the fluctuating drag and lift forces and the mean drag force are affected.

Based on the simulated results, a new equation is proposed to estimate the mean drag force on particles, which is more accurate than the correlations in the literature.

To confirm this theory the fluctuating force experienced by the valve is measured experimentally and the mean drag force is deduced from analytical work presented by Sarpkaya.

It is found that the pressure drop, the mean drag force and the mean pressure gradient force experienced by particles are forced oscillated.

The mean drag force on one subject (an elite skier) whose height and mass were approximately the same as the mean for the entire group was measured in a wind tunnel.

Results showed that significant changes in mean dragging force occurred with changes in both surface texture and slope.

The best floor tested was a floor sloped at 1 10 constructed of timber battens oriented parallel to the path of the drag, which resulted in a mean dragging force 63.6N (15%) lower than the worst combination.

The mean dragging forces for different floor textures and slopes ranged from 359 N (36.6 kg) to 423N (43.2 kg), and were close to the maximum acceptable limits for pulling forces for the most capable of males.

Then, based on the simulated data, a new equation is formulated to calculate the mean individual drag force.

Measurements of mean drag and lift force coefficients, mode-generalized RMS drag and lift force coefficients, and mode-generalized drag and lift force spectra, for a range of cylinder spacings, configurations, and various angles of attack, are presented.