Sentence examples for mean density curve from inspiring English sources

For comparison, the same procedure was applied to the mean density curve (Figure 5).

A mean density curve was subsequently constructed based on these subjects (hereafter called the mean curve).

The segmented lung divided into inner and outer volumes, (a) the mean density curve (solid green line), and its inner (light green area), and outer (dark green area) volume components, as well as the S12 density curve (solid black line), and its inner (black dashed line) and outer (black dash-dotted line) volume components.

Figure 2 Mean density curves and AUC CV T ) distributions.

Figure 2 shows the CV mean density curves and AUC CVT) distributions of the healthy and the COPD distributions for the top-ranked LEHR-125 MBq design and a reduced lung.

(a) The mean density curves of the 40 noise realisations of the CV values for the imaged healthy distribution (black line) and imaged COPD activity distribution (grey line) for the top-ranked LEHR-125 MBq design in Table 5 (a kernel edge length of 2.3 cm, six iterations (96 updates) and a cutoff frequency of 0.7 cm−1).

A hypothetical healthy subject with a density curve resembling the mean curve, as defined in the results of this study, that intersects the fixed point is referred to here as the norm.

A curve-derived theoretical L.O.D. could be considered viable up to 6.63×104 mg−/mg, as this was the corresponding tissue-ratio at which the diglycosylated band's density curve intersects the mean background of the blot.

Following are the 2 calculated structural parameters: (iii) the mean amplitude of the peaks (MP) of the sway density curve.

MP is directly related to the degree of stability obtained by posturographic motor commands; therefore, MP increasing represents an increased quantity of CoP trajectory stable points; (iv) the mean distance (MD) between two consecutive peaks of the sway density curve.

Relative cellular fluorescence intensity was determined by reference to a standard curve generated using the calibration beads and is expressed as mean density normalized by area.