Sentence examples for may considerably reduce from inspiring English sources

Results are reasonable and promising for a good design that may considerably reduce the energy expenses for a continuously heated geothermal spa.

The results suggest that control measurements aimed at reducing transmission to small fish may considerably reduce the absolute amount of fish-borne trematodes.

The core auxeticity may considerably reduce the maximum radial stresses of the face sheets and influence of the auxeticity is more remarkable for plates with more rigid constructions or boundary conditions.

The results indicate that wet deposition (including rain and snow) polluted by anthropogenic SO2, NOx, and NH3 emissions dissolves exposed tufa and may considerably reduce tufa deposition rate and even cause tufa dissolution within shallow waters.

Delayed ettringite formation (DEF) is a rare internal swelling reaction of concrete that, in a wet environment, may considerably reduce the durability of a structure or a member that has been prefabricated in a factory.

Simulations conducted on case study network representing a typical Italian 4-wire LV distribution system under different load/generation conditions, demonstrate that the coordinated action of single-phase and three-phase inverters may considerably reduce the degree of unbalance thus improving the network power quality levels.

Considering priorities in the reconstruction process may again considerably reduce the number of alternative solutions.

While testing for G6PD deficiency is widely recommended prior to the radical treatment of Plasmodium vivax with 14 days of primaquine, P. falciparum transmission may be considerably reduced by a single, low dose of primaquine (1, 7) and may avoid the necessity to screen for G6PD deficiency.

Additionally, when asked to estimate the time taken to perform these procedures, respondents may have based their responses on the time taken to monitor and manage stable warfarin residents, which may have considerably reduced the subjective time estimate, as initiation procedures were by far the most time-consuming based on the quantitative time estimates.

The obtained results showed that the heat flux spent to cure the resin-fiber system may be considerably reduced producing a significant decrease in process cost.

In spite of this, it is found that there are certain situations concerning uniform rods in which the effects of the non-uniqueness of the solution may be considerably reduced by means of a careful choice of the data.