Your English writing platform
Discover LudwigExact(4)
The maximum working frequency of FBG was calculated according to its dynamic strain response.
This study was performed considering the chip area used by the design and the maximum working frequency.
Maximum working frequency of 3 GHz is allowed for performance analysis of radiating antenna.
Maximum working frequency of 3 GHz is specified for excitation source.
Similar(56)
The implementation demonstrates that the proposed architecture can deliver a high reduction of the FPGA logic requirements with high maximum work frequency.
Therefore, the parallel/serial and serial/parallel converters to Wi-Fi Xbee RF modules limit the transmission rate up to the maximum work frequency, depending on the considered FPGA technology.
In summary, considering a synchronous system at the maximum work frequency allowed between the key stream generators and parallel/serial or serial/parallel converters, the limitations with respect to 54-Mbps and 25-kbps bit rates of the Wi-Fi and Zigbee RF modules are due to the work frequencies of hyperchaotic Lorenz generators and the serial interface data rate, respectively.
To avoid this structural resonance, the lowest fundamental frequency of the whole UAV structure has to be higher than the maximum working excitation frequencies of the propellers.
Parameters of the prototype is as follow: length of 34 mm, cross section of 10.5 mm × 10.5 mm, weight of 7.0 g, working frequency of 54.2 kHz, maximum no-load speed of 392 mm/s and maximum thrust of 1.2 N.
The working frequency of the prototype, the maximum speed, and the maximum thrust force are measured to be 33.15 kHz, 1563 mm/s, and 158.2 N, respectively.
It is shown that the maximum power output density only depends on the maximum allowable stress of the beam and the working frequency of the device, and these two factors can be obtained by adjusting the geometry of piezoelectric layers.
Write better and faster with AI suggestions while staying true to your unique style.
Since I tried Ludwig back in 2017, I have been constantly using it in both editing and translation. Ever since, I suggest it to my translators at ProSciEditing.

Justyna Jupowicz-Kozak
CEO of Professional Science Editing for Scientists @ prosciediting.com