Sentence examples for maximum weight fraction from inspiring English sources

The lower the degree of polymerization of the oligomers, the higher the number of broken bonds of the maximum weight fraction.

The viscoelastic properties of the PB1/PDMS blends increase systematically with an increasing the weight fraction of PB1, and then exhibit plateau values above a certain maximum weight fraction (Ωm) of PB1.

Both electrolyte families present an ionic conductivity maximum for some weight fraction of the structural block (wBTFSI), named BTFSI.

The compressive strength of neutralized SPHs decreased monotonically with AA concentration, while the maximum swelling was observed around the AA weight fraction of 0.4 for all PEI concentrations.

The maximum of the pore size distribution for a weight fraction of 22 wt % PEG200 in the polymerization mixture is located at 54 nm, and a maximum in the BJH pore volumes of a respectable 2 cm/g was achieved (Table 1).

The values of maximum mass loss rate decreased roughly with increasing filler weight fraction, while the influence of the filler diameter and length diameter ratio on the maximum mass loss rate was insignificant.

The results showed that the 0.25 wt% CNTs is the optimum weight fraction in terms of achieving maximum strength at a reasonable cost.

The 55,000 molecular weight fraction, after further purification, showed a maximum cadmium concentration of 1.4% by weight.

A maximum obtainable stiffness of the composites is calculated at a certain transition fibre weight fraction, which is characterised by a best possible combination of high fibre volume fraction and low porosity.

Here, a maximum of the pore size distribution located at 9 nm could be clearly observed at a PEG200 weight fraction of 18 wt % (half-filled circles in Figure 3b).

The maximum values of H EB = 600 Oe and coercivity H C = 990 Oe are obtained when the Ni weight fraction is 15%%.