Sentence examples for maximum water absorption from inspiring English sources

However, while minimum compressive strength were measured as 28.5 N/mm2 on the concrete samples prepared with 0% (Reference samples) chemical additives the maximum water absorption were measured as 5.9% on the same samples.

Subsequent impermeable investigations showed that as adding average 3.75% compound admixture into C30 and C40 OCC, the external hydraulic water intrusion results decreased 30% and 18% respectively, chloride ion invasion number decreased 27%and38%8% separately, the maximum water absorption decreased 57% and 55% meanwhile reaching saturated status obviously earlier.

The superabsorbent had a maximum water absorption capacity of 1,014 g/g at pH 7.3; the absorbency was affected by the salinity of the medium.

The study of swelling kinetics produced a rate parameter for the superabsorbent in distilled water of 5.4 min. The maximum water absorption capacity of the superabsorbent was achieved at pH 7.3.

The results showed maximum water absorption for the neat polyamide film 16.1% due to exposure of amide and sulfonyl polar groups to the surface of polymer where water molecules developed secondary bond forces with these polar groups.

The study by Dernovšková, et al.,[35] investigated the amount of water absorbed by parchments at different RH, and found that 16th century (historical) parchments typically absorb more water than new parchments, and that the maximum water absorption was achieved at 45.5% RH and 28.1% RH respectively.

Barrier properties were determined by measuring the maximum water uptake, water absorption rate and coefficient of diffusion.

Diode lasers at a wavelength of 980 nm have been used in a few studies involving LITT in the brain, specifically chosen due to the local maximum in water absorption at this wavelength [ 8, 9].

Thus, 2% cellulase is optimal because this concentration of cellulase exhibited the maximum decrease in fabric stiffness and shrinkage; and maximum increase in water absorption, elongation at break and GSM as compared with the other concentrations.

The effect of both fractions of RAP on optimum moisture content (OMC), maximum dry density (MDD), compressive strength, water absorption and permeable voids were studied.

The engineering assessment included particle size distribution, particle density, water absorption, minimum and maximum dry densities with a vibrating table, California Bearing Ratio (CBR) and Los Angeles (LA) abrasion tests.