Potentiodynamic testing demonstrated that lower initial voltages (−266 < 153 mV), greater <span class="lh">maximum voltage changes (116 > 56 mV, p<0.05, t-test) and voltage variability (3 > 0.5 mV, p<0.05, t-test) were associated with the open circuit potentials of Co-alloy on Co-alloy junctions when compared to zirconia on Co-alloy junctions.
The simulations computed AP waveforms (Fig. 5 A ), CLs (Fig. 5 B ), AP durations (APDs; Fig. 5 C ), peak AP amplitudes (Fig. 5 D ), maximum rates of voltage change during the AP [(d V/d t max], which, in turn, would provide an indication of alterations in conduction velocity at the multicellular level (E), and minimum diastolic potential (MDP; Fig. 5 F ).
Local activation times (LATs) were calculated as the time from stimulation to the maximum negative rate of voltage change, (d V/d t max of the extracellular atrial electrogram recording of the AP.
Hussaini and Wang [18] empirically correlated maximum voltage undershoot to the size of change in HFR.
It is noticed that change is not observed for the maximum voltage level, but a slight decrement is observed after connecting the optimum size of DGs according to Case 2C.
The IEF involved a ramped voltage change delivered over 3 steps up to a maximum of 20 000 V. After IPG strip equilibration, each strip was placed onto a 10%to15%5% gradient polyacrylamide slab gel (8 × 7 cm) for the second dimension (2D) electrophoresis.
maximum voltage at P MAX.
4-tert-butylpyridine. maximum voltage.
These curves are parameterized by maximum voltage, state of charge, internal resistance, polarization voltage, polarization resistance, instantaneous drawn current, and low-pass filtered current (which models the slow response of the battery to a change in load).
During operation, a maximum voltage of 562.67 V/m3 was achieved.
