Ai Feedback
Exact(9)
Low average discharge current was used with maximum value about 1 A.
The power transfer efficiency achieves the maximum value (about 30%) when the frequency is 13.56 MHz.
First, the surface contact potential difference (CPD) strongly increases inside the GO flake and reaches the maximum value about 160 mV at 140 °C annealing.
In hydro-bulge test, the maximum expansion ratio increased as temperature increasing and reached the maximum value about 30% at 170 °C, then decreased quickly at higher temperature until 230 °C.
With the increase of the tensile stress, the ratio increases to the maximum value (about 200%) when the tensile stress is 350 MPa, which is about eightfold over the original sample and higher than traditional materials.
The eddy transport of the total heat energy from the sea surface to the atmosphere was estimated as about 410 which whish is roughly similar to the mean value (about 510 W/m2) and about half of the maximum value (about 780 W/m2) observed during the AMTEX '74 cold period.
Similar(51)
However, at the evidently lowest partial pressure varying within one order of magnitude and reaching a maximum value of about 4 × 10−9 mbar at about 180°C.
The average crystallite size varied between 13 nm and 15 nm for the HCl concentration <1 M and increased slightly for the HCl concentration >1 M and achieved the maximum value of about 19 nm at 4 M HCl.
Consequently, acetate accumulated in the reactor, and reached maximum value at about 72 h.
Therefore, oxygen levels during the experiments were at a maximum value of about 120 μM during circulation periods, and obviously decreased when the vessels were isolated, due to oxygen consumption by experimented animals.
The measured end slips were very small with the maximum values of about 0.1 and 0.12 mm at the supports in 3LT-70-3 3LT-70-3 3LT-70-3pectively.
Write better and faster with AI suggestions while staying true to your unique style.
Since I tried Ludwig back in 2017, I have been constantly using it in both editing and translation. Ever since, I suggest it to my translators at ProSciEditing.

Justyna Jupowicz-Kozak
CEO of Professional Science Editing for Scientists @ prosciediting.com