Sentence examples for maximum tip radius from inspiring English sources
Gold-coated, reflective probes (NSG10) were used with an intermediate spring constant k = 11.5 N/m, a maximum tip radius of curvature of 10 nm, and a resonance frequency of 190 to 325 kHz (Europe MicroMasch, Tallinn, Estonia).
In an additional analysis, four ratios (R/hmax) between indenter tip radius and maximum penetration depth were simulated to analyze the combined effects of R and σr on the indentation load displacement curves.
The probe employed during the fabrication tests was SiN Au-coated Olympus OMLC-RC 800 (k = 0.042 Nm−1, typical tip radius 430 nm), and the maximum bias applicable is ±20 V.
Needle thickness at maximum penetration point is 0.15 mm, and the needle tip radius is 2 μm.
Increasing the dislocation density and tip radius, i.e. the region with maximum shear stress below the tip, resulted in a reduction in the pop-in probability.
The rotor geometric optimization showed that by increasing exit tip radius by 10% and adopting a 54° back-swept blade design, the maximum isentropic efficiency achieved can exceed 83%.
It is dependent on four parameters: the maximum fin effectiveness, the ratio of the coefficient at the fin tip to the coefficient along the side of the fin and the ratios of the fin base radius to the half fin thickness and the fin tip radius to the half fin thickness.
The tip radius was determined with two different methods.
Nominal tip radius was less than 10 nm.
Cantilever producers commonly specify tip radius r < 10 nm.
