Sentence examples for maximum thickness that from inspiring English sources

Full-thickness free-skin grafts are the maximum thickness that can survive without a blood supply, and they are therefore in some danger of failure to survive.

It can be seen from Fig. 10a that the maximum thickness that can be measured in this way, will not exceed 230 μm.

The slip amounts on the single fault model of 10 m and 15 m generated tsunamis that deposited sediment layers with maximum thickness that are comparable with the maximum thickness of the measured sediment layer.

In order to extend the dynamic range of thickness measurement, plots b and c can be divided to obtain (d), where the maximum thickness that can be measured is larger than 250 μm.

It was found that the drying critical thickness, i.e., the maximum thickness that can be reached without film cracking, was greatest when the solvent alcohol was propanol, despite the tensile strength of the gelled network being the lowest.

The Joban sedimentary basin is located offshore and consists of a nearly continuous sequence of sedimentary rocks of about 5,000-m 5,000-m thickness that has been deposited on the basemaximumcks since lathicknessethatous (Figure 1b; Inaba et al.2009).

Varying the overall panel thickness between a minimum and a maximum thickness indicted that an optimal overall thickness could be established.

The experimental findings demonstrate how the role of the interface is crucial and how micro-corrugation is extremely beneficial in increasing the threshold of the maximum thickness beyond that at which coating bulging and delamination occur.

Locating these structures, and determining the localities of maximum sedimentary thicknesses that consist mainly of sandstone, serves as a preliminary process in exploring the confined aquifer beneath the surface of the Abu-Rodaym area.

Results show that at every pumping power, there are particular values of channel width and fin thickness that provide maximum output power in the TEG.

It was found that the film thickness that had the maximum rms roughness via surface roughening provides the required thickness information needed for fabricating the low-stress PZT cantilever.