Sentence examples for maximum temperature which from inspiring English sources
This is because the AT is calculated by using daily minimum relative humidity instead of relative humidity occurring at the time of the daily maximum temperature, which is not available in the current models.
Obtained results demonstrated no significant difference in thermo-mechanical fatigue lifetime of the A356.0 alloy between non-heat-treated and heat-treated test specimens at 250 °C of the maximum temperature, which was attributed to the over-ageing phenomenon.
A recommendation has been made for separating studies of the effect of simulated fire temperatures on the residual strength of steel into two classes (low and high temperature), depending on whether a critical maximum temperature (which depends on alloy composition) is exceeded and the science underlying this recommendation has been discussed.
This radiation loss reduces the maximum temperature which can be achieved in the system.
The excess of the implanted deuterium dose 1.8 × 1017 D/cm2 is accompanied by a gradual decrease in the b peak maximum temperature, which becomes equal to 430 K at a dose of 6.4 × 1017 D/cm2.
Maximum temperature thresholding: From each two minute block of data the function produces a single composite image of maximum temperature, which is constructed from the maximum value at each pixel position through that time span (Patrick et al. 2010).
This higher value could also be obtained at lower maximum temperatures, which would lengthen the catalyst life.
The maximum temperatures which still guarantee sufficient short-time stability of the bioslurries have not been investigated in detail so far.
Moreover, climate extremes derived from daily minimum temperatures were more numerous that the extremes derived from daily maximum temperatures, which was found to be consistent with the significantly decreased DTR.
The temperature ratio that figures into the efficiency of the elementary Carnot cycles is the inlet temperature divided by the compressor exit temperature, not the maximum cycle temperature, which is at the combustor exit.
The most critical design parameter of interest was the maximum thimble temperature, which is limited by the melting temperature of the filler material in the brazed finger joint.
