Sentence examples for maximum temperature obtained from inspiring English sources

The maximum temperature obtained at the back of the panel was calculated as 37 °C and the panel efficiency was 11% at mean solar radiation was 2000 W/m2.

Characterization using infra red thermography highlighted the thermal protective behavior of the SWCNT film; the maximum temperature obtained from a 5.2 kW/m2 heat flux exposure was 50 °C lower than that for the two (SWCNT, CB) PAN-MA based films.

Indeed the maximum reaction rates are greatly reduced causing a decrease in the maximum temperature obtained in the reaction zone.

It is detected that the maximum temperature obtained in the reaction is slightly reduced with rise in the feed flow rate.

Figure 7 presents the variations in the maximum temperature obtained in the reaction with the rise in the feed flow rate, keeping the sweep and fuel flow rate constant.

Open image in new window Fig. 6 Effect of feed flow rate on the oxygen permeation for reactive cases Open image in new window Fig. 7 Effect of feed flow rate on the maximum temperature obtained Open image in new window Fig. 8 Contours of temperature with increasing air feed flow rates.

Maximum temperatures obtained ranged 46.8 54.5 °C.

The temperature evolution models are calibrated against present-day RFT temperature measurements corrected after Andrews-Speed et al. (1984), vitrinite reflectance data, maximum temperatures obtained from apatite fission-track analyses and paleo-temperatures obtained from fluid inclusions in mineral cements (Table 5) (Swarbrick et al. 2000; di Primio and Neumann 2008).

Meanwhile, the maximum interface temperature obtained when the ethanol droplet is added to the faying surface.

The crosslinking process was followed by static and dynamic viscosimetry and by differential scanning calorimetry (d.s.c).. Activation energies were determined from the gel times obtained by viscosimetry and from the variation in the maximum exotherm temperature obtained by d.s.c. at different heating rates.

But further augmentation in the sweep flow rates reduces the maximum flame temperature obtained.