Sentence examples for maximum temperature drop from inspiring English sources

The heat exchangers should be designed in such a way as to obtain a maximum temperature drop of the geothermal fluid.

In this work, a new design concept which combines two-stage design with transient supercooling effect is proposed to enhance the maximum temperature drop across thermoelectric coolers (TECs).

Results was analysed and it was concluded that minimum time taken and maximum temperature drop was achieved with the installation of both the equipment on the same side of the room.

The shortest current period to achieve a periodical supercooling effect is greatly subject to the temperature overshoot because the maximum temperature drop is approximately identical in each subsequent current periods.

For PC film, it was found that the heat transfer retardation results in the mold temperature drop in cavity surface and the maximum temperature drop as compared to that of conventional injection molding without film may be as high as 17.7 °C.

Experimental results showed that the CLHP could successfully realize the supercritical startup with an auxiliary heat load of 1.5 W, and there existed an optimum auxiliary heat load and charged pressure of the working fluid respectively, to achieve the maximum temperature drop rate of the primary evaporator during the supercritical startup.

The southern coast is generally cooler than the inland areas, except for the mountains, where in the highest elevations the average maximum temperature drops to less than 38 °F (3 °C) in winter.

On average, the mean temperature during August was 3.7°C lower in areas with irrigated crops, and the maximum temperature dropped an average of 7.5°C.

As can be seen from Figure 6 and Table 8, after irradiating "Hoku" for 10 minutes, the average temperature decreased by 0.3°C, but the maximum temperature dropped by 0.25°C; the minimum temperature rose by 0.05°C.

In the affected areas, monthly mean maximum temperature dropped from 28.3°C in June to 26.4°C in August, and total monthly rainfall amount fell from 126.4 mm in May to 44.8 mm in August.

For PET film, this maximum mold temperature drop is about 13 °C.