However, it is possible that their curves go up and reach the maximum SINR target value.
A supercritical fluid extraction (SFE) process was optimized by employing a 5-level-3-factor central composite design to achieve maximum target response values for total extract yield, ST yield, Reb-A yield and total phenolic content of 15.85%, 95.76 mg/g, 62.95 mg/g and 25.76 mg GAE/g, respectively.
(iii) The control parameter is varied from 0 (perfect synchronization) to (maximum target synchronization mismatch value to be tested) to obtain the synchronization mismatch acuity threshold.
The model was trained using different combinations of these parameters so as to achieve maximum determination coefficient values (target value = 1, i.e., 100% correlation between measured and predicted variables).
For the analysis of unlabeled peptides, the instrument method consisted of a full MS scan (scan range 375 1550 m/z, with 30K FWHM resolution @ m/z = 400, target value 2×106, maximum ion injection time of 500 ms) followed by data-dependent CID scans of the six most intense precursor ions.
For ETD-MS/MS, the AGC target value and maximum injection time was the same as the CID-MS/MS experiments, while the AGC target value and maximum injection time of the fluoranthene reagent anion were set at 2.0 × 10 and 100 ms, respectively.
Survey full scan MS spectra (m/ z 375 1800) were acquired in the Orbitrap with 70 000 resolution (at m/ z 200) after accumulation of ions to a 3 × 10 target value with maximum injection time of 120 ms.
When the CDS was queried against NCBInr protein database with an E value 1e-50 and maximum target sequences 100, the top seven hits were matched to six Colletotrichum spp. (with an E value 0 and 95 99 % query coverage) and the remaining 93 hits were matched to the kingdom Prokaryota/Bacteria (68 hits with an E value 0 and 89 97 % query coverage).
Spectra were acquired in the Orbitrap at a resolution of R = 60,000; the AGC target value was 1,000,000; maximum ionization time was set to 100 ms.
In order to improve the efficiency of the mechanical hydraulic transmission, we select the hydraulic control target value as the maximum power load.
