Sentence examples for maximum surface tension from inspiring English sources
The minimum and maximum surface tension values for each pulsation cycle were extracted and plotted.
3 6), maximum surface tension values were higher than those of CLSE during cycling on both the pulsating and captive bubble surfactometers (e.g., Figs. 5, 6).
However, maximum surface tension values for DEPN-8+1.5% Mini-B were higher than for CLSE on both the pulsating and captive bubble surfactometers.
Detailed values of maximum surface tension during cycling for DEPN-8+1.5% Mini-B and CLSE are shown later for studies on the captive bubble surfactometer.
Maximum surface tension values for DEPN-8+1.5% Mini-B during cycling on the pulsating bubble apparatus were 9 20 mN/m higher than those of CLSE at a given surfactant concentration (data not shown).
However, maximum surface tension values for DEPN-8+1.5% or 3.0% Mini-B for all cycles were greater than those of CLSE at the quasi-static and dynamic compression rates studied on the captive bubble (Figures 5 and 6, respectively).
Although minimum surface tension is a primary indicator of lung surfactant activity, maximum surface tensions were also assessed in pulsating bubble studies.
The pressure in the liquid phase was measured with a precision transducer, and surface tensions at minimum and maximum bubble radius (minimum and maximum surface tensions) were calculated as a function of time of pulsation from the measured pressure drop across the air-water interface using the Laplace equation for a sphere [67], [68].
A final parameter that was considered in the surfactometer studies was the range, in other words, the difference between maximum and minimum surface tension that was observed for each test solution during cycling.
Pulsating bubble surfactometry and Langmuir-Wilhelmy surface balance studies showed that alkylation improved biomimetic surface activities, yielding lower film compressibility and lower maximum dynamic surface tensions.
This parameter demonstrates maximum reduction of surface tension, and the higher the Πcmc values, the greater is the effectiveness of the surfactants.
