Sentence examples for maximum stresses at from inspiring English sources

The unidirectional strength is achieved by computing and optimizing the results of maximum deflection and maximum stresses at the location where maximum loads are applied.

Von Mises analysis has shown the maximum stresses into the canal in groups restored with metallic posts, while glass-fiber posts and CC presented the maximum stresses at load contact point in the crown.

This difference can be attributed to the design of the homogenisation chambers with the HPH producing a wide distribution of shearing forces, so all of the starting emulsion does not experience the maximum stresses at each pass.

A parametric study indicates that the maximum stresses at the notch locations increased with the notch depth and the applied bending moment on notched cross-sections, but reduced with the thickness of the adhesive.

The ratios of maximum stresses at the integrated parts among Latero, SynFix and Stabilis models were 1: 9.6: 2.7 in extension, 1: 2.9: 0.2 in right lateral bending, and 1: 2.2: 0.4 in right axial rotation, respectively.

Young's moduli and the maximum stress-at-break of the swollen hydrogels were normalized on the basis of their polymer content.

The maximum stresses appear at the applied loads, at the opening position and at their surrounding area in B1, B2, B3, B4, B5 and B8 beams and on the opposite side the maximum stresses appear at the applied load position and the surrounding area in B6, B7 and B9.

For the retracted position, maximum stresses occur at the supporting cables.

Additionally, Figs. 7, 8, 9, 10, 11, 12, 13, 14 and 15 illustrate that in B1, B2, B3, B4, B5 and B8, the maximum stresses appear at the loads and the opening position and the surrounding area and on the opposite side the maximum stresses appear at the load position and the surrounding area.

Maximum stresses arise at the interface between supporting saddles and cylinder walls, that is in corresponding of the constraint sections, where, in absence of section increments, a stress increase is reasonable.

In the TomoFix plate with bone graft, those maximum stresses appeared at the screw hole just above the osteotomy on the inner side of the plate.