Sentence examples for maximum stress was from inspiring English sources

The model-fitted maximum stress was about 50 kPa higher than the inflation pressure.

It was observed that the maximum stress was experienced near the periphery of the top surface and ΔTC was more for thicker samples.

For creep properties, apparent strain at 6 MPa suggested that special attention was necessary for analyzing structural behavior if maximum stress was larger than 6 MPa.

The maximum stress was set at a value corresponding to 20% of the calculated ultimate tensile strength (UTS) of 100 MPa.

In each case, the response surface function for determining the maximum stress was composed of combinations of the four design variables.

The results show that the maximum stress was higher than 1.5Sm, and the BM design has been modified to satisfy the BM function and requirements.

From the FE analysis, it can be seen that the maximum stress is 360 MPa when there is no applied current and the maximum stress is 409 MPa when the applied current is 0.36 A.

It is shown that the location of the maximum stress is also affected by the penetration spacing.

Maximum stress is found near the basement of baffle plate support legs and close to design limit.

However, the SWT parameter cannot deal with the uniaxial fatigue conditions where the maximum stress is low or negative.

Counterintuitively, the overall maximum stress is not found when the bag is filled to its maximum capacity (when the filled cryobag resembles a sphere).