Sentence examples for maximum stress strength from inspiring English sources

It was observed that the maximum stress strength would be attained for nanocomposite films with 6% (by weight) of clay loading.

Using randomized stress-strain-temperature relationships, based on variability of the different governing parameters (under tension: maximum stress, 0.2% proof stress, corresponding strains at maximum stress (strength) and failure; under compression: Young's modulus, proportional limit, 0.2% proof stress and the maximum stress), the probability distribution of moment capacity has been calculated.

The fracture ESO algorithm considerably improves the residual strength by decreasing the maximum stress intensity factor.

Lower bound solutions are obtained for the maximum thermal shock that the plate can sustain without catastrophic failure according to the two distinct criteria: (i) maximum local tensile stress equals the tensile strength of the solid, and (ii) maximum stress intensity factor for the pre-existing representative crack equals the fracture toughness of the solid.

It has also been observed that the maximum stress intensity in girdle wire does not increase beyond the ultimate tensile strength even when maximum stress intensity in calandria tube reaches its yield strength.

Beyond the yield point, the stress increases again with strain (strain hardening) up to the maximum stress (ultimate strength,f ult ) when it decreases until failure at about a stress quite close to the yield strength.

Strain rate sensitivity is measured with in terms of the stress strain curves, the maximum stress (flexural strength), dynamic increase factor, elastic modulus and Poisson's ratio.

The fatigue ratios (= the maximum stress range/yield strength corresponding to the fatigue cycles equal to 107) of the BMG composite and the BMG are 0.23 and 0.12, respectively.

The area under the curve and the maximum stress or strength required to rupture the film determine its toughness [ 14].

It was found that the guidelines significantly under-predict the strength, maximum stress and strain in CFRP confined columns.

However, the maximum stress (referred to as strength), at which fibril is significantly ruptured, is measured as ~620 MPa for both prion and non-prion fibrils (Fig. 3).