Sentence examples for maximum stress position from inspiring English sources

Helbawi et al. [45] found that the maximum stress position shifted away from the bonded-interfaces in both finite element simulation and indentation experiments.

The depth of the compressive region increased with the rolling force and the maximum stress position also tended to be subsurface, while for lower loads the maxima were at the surface.

The maximum stress positions are on the lee side corner of the container.

Analytical procedures often fail to predict correctly the maximum stress and its position, a new, more reliable method is needed for that purpose.

The proposed modeling accounts for the spatial traction profile along the interface between the adherends using few degrees of freedom, i.e. crack tip position, maximum stress and size of the process zone.

As expected, for the advanced position of the hydraulic cylinder piston rod, the areas of highest stress concentration are located in the piston rod and in the supporting cables while for the retracted position maximum stress is located in the cables.

The equations not only allow the rapid optimisation of multi-planar joints but also can be used to quickly identify the location of maximum stress concentration and hence the likely position of fatigue cracks.

A rotating turbine disk with a nearly real geometry is used as evaluation object to investigate the effects of different thermal management strategies from three aspects: the position of maximum stress, the iso-surface of the maximum stress level and the variation profile of the disk.

At a tibia rotation 10° off the neutral position the maximum stress value determined at the FP system is 44% higher than the value computed for the RPS system (FP = 26 MPa versus RPS = 18 MPa), first exceeds the material yield strength of 25 MPa and also a deformation of the lateral compartment is visible.

The fracture could be initiated at a position of local maximum stress gradient along with defects.

In the analysis, the number, shape, and spacing of cavities are varied systematically; then the magnitude and position of the maximum stress are examined.