Sentence examples for maximum stress is from inspiring English sources

From the FE analysis, it can be seen that the maximum stress is 360 MPa when there is no applied current and the maximum stress is 409 MPa when the applied current is 0.36 A.

Maximum stress is found near the basement of baffle plate support legs and close to design limit.

It is shown that the location of the maximum stress is also affected by the penetration spacing.

However, the SWT parameter cannot deal with the uniaxial fatigue conditions where the maximum stress is low or negative.

It is also determined that in this case, the maximum stress is over the lower yield point, and the ratcheting strain rate is dominant over the fatigue life.

The effective thermal stress increases during the transient phase of the cooling process and the maximum stress is achieved at the impingement point under steady state conditions.

The model-fitted maximum stress was about 50 kPa higher than the inflation pressure.

Based on dynamic analysis, it was found that the first mode shape, the maximum displacement and, therefore, the maximum stress were exactly situated within the crack initiation zone.

It was observed that the maximum stress was experienced near the periphery of the top surface and ΔTC was more for thicker samples.

Agreement between calculated and measured results obtained was good and areas of the bogie frame with maximum stress were predicted with reasonable accuracy.

The results show that the maximum stress was higher than 1.5Sm, and the BM design has been modified to satisfy the BM function and requirements.