Sentence examples for maximum stress for from inspiring English sources

This transition involves the saturation with impurity atoms of the region between the decohering planes and leads to a dramatically reduced maximum stress for decohesion.

Then, the proposed approach is applied to two real-life cases, modeling of the maximum stress for the structure of a Small Waterplane Area Twin Hull (SWATH) catamaran and predicting weld geometry in fiber laser keyhole welding, to illustrate its ability in support of complex engineering design.

Comparing the maple blades, there was a slight increase in maximum stress for the maple seed blades with tubercles.

According to the expression of maximum stress in the plane of a circular elastic film in[40], the maximum stress for a rectangular elastic film can be expressed by the following formula: σ m 2 D = F max E 2 D 8 πr 1 / 2 (4).

Mal appears when least expected, or perhaps when she should be most expected, i.e., in times of maximum stress for Cobb in his excursions through the mind.

The resulting maximum stress for the filament is predicted to be ≈97 MPa (found at ≈205% strain) from simulation (Fig. 4C), close to experimental measurements of 90 MPa at similar levels of strain [8].

It is found the maximum stresses for three cases are linear to the total amount of intercalated lithium ions.

Additionally, the maximum stresses for a higher power ratio under the range of the current study are always smaller than that of a lower one before reaching the peak values, which is beneficial to avoid thermal stress-related defects.

From the results of the analyses, the maximum stresses for the RB and the reactor vessel occur in the level of hot pool free surface regions after primary pump flow coastdown.

The study proposes a new probe design method for reducing the maximum stress of the probe used for vertical probe card in wafer probing, in which a plurality of circular arcs in different radii are provided to drop the stress so as to avoid the probe being overstressed while in operation.

(a) Two-probe resistance and (b) maximum stress of ITO layer for PI/ITO/PES on bending curvature κ (σy: yield strength).