Sentence examples for maximum strength then from inspiring English sources

He turned the switch further, until the light was at maximum strength, then laughed again, ha-ha-ha, as if he'd just found a toy that pleased him.

Most ILD functions (54.7%) eventually exhibited a decrease in maximum response strength accompanied by lateral shift [Fig. 6A; decrease in maximum response strength accompanied by lateral shift ('Dec/Sf') or increase in maximum response strength then followed by a decrease accompanied by lateral shift ('Inc/DS')].

El Niño conditions normally reach maximum strength between October and January, then persist through much of the first quarter.

Homogenized tissues were then sonicated for 30 s at maximum strength and centrifuged at 10,000× g for 5 min. Supernatants were then overlaid on confluent Vero cell monolayers (2 × 10 cells/well in a 48-well plate) for 1 hr.

These policies apply no control until the occurrence of a triggering event and then apply controls at maximum strength.

Accordingly, the compression zone of concrete crushes and the compressive reinforcement buckles, causing the specimen to lose strength suddenly; then, the applied loading suddenly falls from the maximum strength of 906.5 728.4 kN (79.8%% of the maximum strength) (Fig. 5).

When the deformation reaches 4.0%%, the compression zone of concrete crushes and the concrete cover in the compression zone also spalls; then, the applied loading suddenly falls from the maximum strength of 1039.9 628.1 kN (59.9 % of the maximum strength) (Fig. 7).

In the final step with a deformation of 3%%, the strength decreases to 402.2 kN (48.1 % of the maximum strength) due to the most of concrete near the support area spalls and then the experiment is stopped.

The cell pellets after centrifugation were suspended in 50 mL of 100 mM HEPES buffer (pH 7.5), and then lysed by the Fisher Scientific sonic dismembrator (Model 500) at a 60% maximum strength for 90 seconds.

In the final step with a deformation of 3%%, the strength decreases to 361.1 kN (56.9 % of the maximum strength) due to the most of concrete in the compression zone crushes (shear-compression failure) and then the experiment is stopped.

Then the participant is instructed to squeeze and maintain pressure at 20 to 40percentt of maximum strength for 2 to 5 minutes.