Sentence examples for maximum strains in from inspiring English sources
Facades with different opening layouts (a); relation between number of openings and maximum strains in sagging and hogging cases (b).
The locus of maximum strains in the abutment varied by the surcharge load and time that did not corresponds to the (45+ϕ/2) line, especially after the placement of steel girders.
Open image in new window Fig. 8 Distribution of maximum strains in the transverse-steel at failure (The strain bars are drawn to scale and represented on the recording stirrups. The straight line represents the yield strain limit for the steel stirrups used in this study).
The average across models of the maximum strains in the PDL was 0.240 with a small influence from the material of the ligature (up to 13%) and the bracket (up to 30%) and a large influence from the wire material (up to 127%).
The positions of the maximum strains in the shear bands are indicated by white circles, and this maximum strain is shown in Table 3 Open image in new window Fig. 9 Same as Fig. 8 but for the high-strength material Open image in new window Fig. 10 Effective strains along a straight line from the lower (position on line is 0 mm) to the upper tool edge short before final fracture.
The moment of maximum strain in the discussion of the Dead Sea documents may, perhaps, be fixed on the day May 26, 1950 when Professor Dupont-Sommer read before the French Académie des Inscriptions et Belles-Lettres a paper on the Habakkuk Commentary.
First, the difference between the minimum and maximum strain in the overall field was evaluated.
Monte Carlo sampling techniques were applied and the performance indicator was the maximum strain in the bone.
Maximum strain in the 4 mm surface layer was 0.30% whereas maximum strain in the 6 mm surface layer (opposite side) was 0.20%, detected in the marginal and apical part of implant-poly-methyl-methacrylate sample.
On the other hand, the maximum strain in a beam cannot be measured with long gage optic sensors.
To provide the results for the maximum strain in a 'closed form', an equation fitting technique has been used.
