Sentence examples for maximum strain values from inspiring English sources

Maximum strain values in all models were measured in cortical bone in implant necks.

The results indicated that the maximum strain values of cortical and cancellous bone increased with lower bone density.

The spatial profile of the ratio between the radiative recombination rate of the deflected nanobeam and that of the unstrained nanobeam (Urad,deflected/Urad,unstrained) is illustrated in Fig. 6a for various maximum strain values.

It was observed that the stress-strain curves were similar for all sand replacement levels and that concrete with 100% quarry dust had the maximum strain values.

For each stress level, the corresponding Neuber-Hyperbolas, Masing-loops and their maximum stress and maximum strain values were determined in order to calculate damage parameter (PSWT) values.

Specimens with plasma surface treatment present low maximum strain values, unrelatedly to the particle size.

Maximum strain value of 850% at 0.32 MPa and dielectric permittivity of 4.41 at 10 Hz and 20 °C were obtained.

The maximum strain value corresponds to the high-porosity layer without any low-porosity on top (monolayer).

The obtained deflection results have been compared with other experimental and FE model results in which using concrete element 100 × 42.5 × 42.5 mm, smeared steel distribution, and modeling CFRP with ANSYS 5 program and the results of studied parameters such as the maximum strains values for concrete and steel at failure loads for different opening sizes are very close.

Figure 22 shows the strain results for the top mast in the case of perpendicular loading in which only the maximum and minimum strain values are shown for clarity.

The maximum principal strain values for metal-backed in the trabecular bone below the implant were variable between specimens but close to intact under all conditions.